Influential Factors on Vibration Inherent Characteristics of Sink Roll Device of Hot Dip Galvanized
-
摘要: 为研究沉没辊装置振动固有特性的影响因素,采用有限元技术,开展了沉没辊装置的湿模态和预应力模态分析,分别研究了流体密度、带钢断面及其张力等因素对沉没辊装置振动频率的影响程度及规律,并分析造成频率差异的原因。结果表明:沉没辊装置在锌液中振动时的频率比在空气中减小24.4%~58.8%,且频率随着流体密度的减小而增大;沉没辊装置在带钢断面及其张力等预应力作用下的固有特性影响很小,但一些具有不对称性的振型会减少轴承的工作寿命。Abstract: Sink roll device is a key functional component of zinc pot of hot dip galvanized line. To study the influential factors on vibration inherent characteristics of sink roll device, this paper carries out the wet modal analysis and the prestressed modal analysis of sink roll device based on finite element method and mathematical models. The effects of fluid density, strip section and its tension on the sink roll device of vibration frequency and regularity are studied, and the cause of the difference of frequency is analyzed. The results show that, sink roll device vibration in liquid zinc is reduced when the frequency ratio of 24.4%~58.8% in the air, and the natural frequencies of fluid density decrease with increasing. The sink roll device in strip section and tension prestressed loads has little effect on the natural frequency, but some of the asymmetry of the natural mode of vibration will reduce the bearing service life.
-
Key words:
- finite element method /
- inherent characteristics /
- mathematical models /
- modal analysis
-
[1] 张理扬,李俊,左良.新型带钢连续热镀锌机组的发展[J].钢铁研究学报,2005,17(4):9-13 Zhang L Y, Li J, Zuo L. Development of new continuous hot dip galvanizing line of steel strip[J]. Journal of Iron and Steel Research, 2005,17(4):9-13(in Chinese) [2] 陈培林,周瑾,王泽济.热镀锌带钢抖动特性及其抑制[J].冶金设备,2013,(4):16-20 Chen P L, Zhou J, Wang Z J. Characteristics and stabilization of hot-dip galvanizing strip vibration[J]. Metallurgical Equipment, 2013,(4):16-20(in Chinese) [3] 李健,颜云辉,郭星辉,等.基于薄板固有特性的连续热镀锌带钢表面质量在线控制[J].机械工程学报,2011,47(9):60-65 Li J, Yan Y H, Guo X H, et al. On-line control of strip surface quality for a continuous hot-dip galvanizing line based on inherent property of thin plate[J]. Journal of Mechanical Engineering, 2011,47(9):60-65(in Chinese) [4] 李路雷,蔡忠清,惠升,等.热镀锌生产线出锌锅段带钢-气垫耦合系统振动特性研究[J].机械科学与技术,2015,34(4):526-532 Li L L, Cai Z Q, Hui S, et al. Vibration analysis characteristics of coupling system composed of steel strip and air cushion in continuous hot-dip galvanizing processes[J]. Mechanical Science and Technology for Aerospace Engineering, 2015,34(4):526-532(in Chinese) [5] Kim C H, Perkins N C, Lee C W. Parametric resonance of plates in a sheet metal coating process[J]. Journal of Sound and Vibration, 2003,268(4):679-697 [6] 郑红霞.热镀锌板沉没辊轴套材料腐蚀磨损机理的研究[D].天津:河北工业大学,2006 Zheng H X. Research on corrosion wear mechenism of dip-roll sleeve in hot-dip galvanzing[D]. Tianjin:Hebei University of Technology, 2006(in Chinese) [7] 王洋,许飞,李勇,等.带钢-辊子-柔性支承混杂系统动力学建模与耦合振动研究[J].振动工程学报,2013,26(4):599-607 Wang Y, Xu F, Li Y, et al. Dynamic modeling and coupling vibration analysis of hybrid systems consisting of strip, rolls and flexible supports[J]. Journal of Vibration Engineering, 2013,26(4):599-607(in Chinese) [8] Li J L, Wang X D, Chen X W, et al. Vibration characteristics research of the zinc pot sink roll components based on finite element method[C]//Proceedings of the 2012 Third International Conference on Mechanic Automation and Control Engineering, Washington, DC:IEEE Computer Society, 2012:156-160 [9] 李蛟龙.冷轧带钢热镀锌沉没辊服役周期振动特性研究[D].武汉:武汉科技大学,2012 Li J L. Vibration characteristics research during service life of sink roll in cold-rolling strip steel hot-dip galvanizing line[D]. Wuhan:Wuhan University of Science and Technology, 2012(in Chinese) [10] Jeong K H, Kang H S. Free vibration of multiple rectangular plates coupled with a liquid[J]. International Journal of Mechanical Sciences, 2013,74:161-172 [11] Li X J, Chen L Q. Modal analysis of coupled vibration of belt drive systems[J]. Applied Mathematics and Mechanics, 2008,29(1):9-13 [12] Kim Y H, Cho Y W, Chung S H, et al. Numerical analysis of fluid flow and heat transfer in molten zinc pot of continuous hot-dip galvanizing line[J]. ISIJ International, 2000,40(7):706-712 [13] 童淦波,彭军,王转新,等.连续热镀锌生产线实用新型沉没辊研究[J].采矿技术,2004,4(3):59-60 Tong G B, Peng J, Wang Z X, et al. Research on the utility model sink roll in continuous hot dip galvanizing line[J]. Mining Technology, 2004,4(3):59-60(in Chinese) [14] 张忠原.基于Solidworks和ANSYS的改向滚筒有限元分析[J].矿山机械,2014,42(3):47-50 Zhang Z Y. FEA of bend pulley based on Solidworks and ANSYS[J]. Mining & Processing Equipment, 2014,42(3):47-50(in Chinese) [15] Zhou Q, Joseph P F. A numerical method for the calculation of dynamic response and acoustic radiation from an underwater structure[J]. Journal of Sound and Vibration, 2005,283(3-5):853-873 [16] 贾艳敏,王佳伟,韩基刚.预应力简支钢箱梁固有频率影响因素分析[J].工程力学,2009,26(S1):37-40 Jia Y M, Wang J W, Han J G. Analysis of influentional factors on natural frequencies of simply supported steel box girder with prestressed tendons[J]. Engineering Mechanics, 2009,26(S1):37-40(in Chinese)
点击查看大图
计量
- 文章访问数: 224
- HTML全文浏览量: 34
- PDF下载量: 12
- 被引次数: 0