Lumped Parameters Model Identification of Hydraulically Damped Rubber Mount Based on Characteristic Frequency Points Method
-
摘要: 探讨应用动态特性特征点法预测与识别液阻悬置集总参数模型主要参数的分析方法。该方法首先通过实验来得出液阻悬置动态特性特征点,运用傅里叶变换的方法对液压悬置的集总参数模型进行深入推导得到液压悬置的复刚度,然后通过建立的动态特性特征点与集总参数之间的关系求解得出集总参数的值。通过对数值预测结果与实测结果对比分析表明,基于动态特性特征点法的液阻悬置集总参数模型动特性分析技术是可行、有效的,其预测结果精确性满足工程要求。Abstract: Characteristic feature point methods and computational fluid dynamics(CFD) methods were applied to prediction or identification of the model parameter. The dynamic characteristic feature points were obtained with testing dynamic characteristics of the hydraulically damped rubber mount(HDRM) firstly and the complex stiffness of hydraulically damped rubber mount was derived from lumped parameters(LP) model by Fourier transform, and then the LP model was calculated by the relation developed between the feature points and the lumped parameters. The results were compared with experimental data,the work conducted in the paper demonstrates that the method for estimating the system parameters in the LP model of HDRM is effective.
-
[1] Flower W C. Understanding hydraulic mounts for improved vehicle noise, vibration and ride qualities[R]. SAE Paper 850975, 1985 [2] Singh R, Kim G, Ravindra P V. Linear analysis of automotive hydro-mechanical mount with emphasis on decoupler characteristics[J]. Journal of Sound and Vibration, 1992,158(2):219-243 [3] Kim G, Singh R. Nonlinear analysis of automotive hydraulic engine mount[J]. Journal of Dynamic Systems Measurement and Control, 1993,115(3):482-487 [4] Geisberger A, Khajepour A, Golnaraghi F. Non-linear modelling of hydraulic mounts:Theory and experiment[J]. Journal of Sound and Vibration, 2002,249(2):371-397 [5] Lee J H, Bae M S, Kim K J. Limitations of mechanical model with lumped mass in representing dynamic characteristics of hydraulic mount[R]. SAE Paper 2003-01-1466, 2003 [6] Brach R M, Haddow A G. On the dynamic response of hydraulic engine mounts[R]. SAE Paper 931321, 1993 [7] 吕振华,上官文斌.基于液-固耦合有限元仿真的液阻悬置集总参数模型动特性分析[J]. 机械强度,2004,26(1):29-37 Lv Z H, Shangguan W B. Dynamic characteristic analysis of hydraulically damped rubber mount:LP model based on FSI FE simulation[J]. Journal of Mechanical Strength, 2004,26(1):29-37(in Chinese) [8] 陈无畏,王景蓉,陈晓新,等.基于ALE有限元法的发动机液压悬置动态特性仿真[J]. 合肥工业大学学报,2011,34(5):641-645 Chen W W, Wang J R, Chen X X, et al. Dynamic characteristic simulation of hydraulic engine mount based on ALE Finite element method[J]. Journal of Hefei University of Technology, 2011,34(5):641-645(in Chinese) [9] 徐中明,李晓,刘和平.纯电动汽车动力总成悬置系统的优化[J]. 汽车工程,2012,34(9):806-810 Xu Z M, Li X, Liu H P. Optimization of the powertrain mounting system of electric vehicle[J]. Automotive Engineering, 2012,34(9):806-810(in Chinese) [10] 张云侠,张建武,上官文斌,等.直接解耦盘式液阻悬置的动力学研究[J]. 上海交通大学学报,2007,41(9):1406-1410 Zhang Y X, Zhang J W, Shangguan W B, et al. The dynamic response of direct-decoupler hydraulic mount[J]. Journal of Shanghai Jiaotong University, 2007,41(9):1406-1410(in Chinese) [11] 宋发宝,马力,张宇龙,等.整车刚柔多体全浮式驾驶室悬置隔振仿真[J]. 农业机械学报,2008,39(8):41-43,32 Song F B, Ma L, Zhang Y L, et al. Vibration isolation suspension system for commercial vehicle full-float cab based on theory of rigid-flexible dynamics[J]. Transactions of the Chinese Society for Agricultural Machinery, 2008,39(8):41-43,32(in Chinese) [12] Song H, Singh R. Estimation of amplitude and frequency dependent parameters of hydraulic engine mount given limited dynamic stiffness measurements[J]. Noise Control Engineering Journal, 2005,53(6):271-285 [13] 吕振华,梁伟,上官文斌.汽车发动机液阻悬置动特性仿真与实验分析[J]. 汽车工程,2002,24(2):105-111 Lü Z H, Liang W, Shangguan W B. Simulation and experimental analyses of dynamic characteristics of automotive engine's hydro-elastic mount[J]. Automotive Engineering, 2002,24(2):105-111(in Chinese) [14] 吕振华,上官文斌,梁伟,等.液阻悬置动态特性实验方法及实测分析[J]. 中国机械工程,2004,15(2):182-186 Lü Z H, Shangguan W B, Liang W, et al. Experimental methods and test evaluation for the dynamic characteristics of hydraulically damped rubber mount[J]. China Mechanical Engineering, 2004,15(2):182-186(in Chinese) [15] 王峰,靳永军,张建武.基于整车模型的动力总成悬置振动仿真及优化[J]. 振动与冲击,2008,27(4):134-138 Wang F, Jin Y J, Zhang J W. Vibration simulation and optimization of a powertrain mounting system based on a full vehicle model[J]. Journal of Vibration and Shock, 2008,27(4):134-138(in Chinese)
点击查看大图
计量
- 文章访问数: 165
- HTML全文浏览量: 32
- PDF下载量: 10
- 被引次数: 0