Research on Coupling Mechanism of Contactless Power Supply System for Water Film Pressure Monitoring Node
-
摘要: 水润滑轴承水膜压力无线监测节点同轴安装、随轴高速旋转,因此对其供电成为一大难题。针对上述问题,提出一种非接触供电方法,建立了耦合机构物理模型及其等效电路,并进行特性分析;然后,对耦合机构原、副边电路进行补偿,并对其输出功率及效率进行仿真;最后通过试验进行验证。结果表明:仿真与试验结果具有较好一致性,该耦合机构在SP补偿后平均输出功率为10.332 W,传输效率为69.84%,能够满足无线监测节点非接触供电需要。Abstract: Since the water-film pressure wireless monitoring node of water-lubricated bearing is installed coaxially and rotating with the shaft at high speed, its power supply becomes vital importance and difficult. To solve the above problems, a contactless power supply method was proposed in this study, the physical model of coupling mechanism and its equivalent circuit were established, and its characteristics were analyzed. Then, the primary and secondary side circuits of the coupling mechanism are compensated, further the output power and efficiency are simulated. Finally, it is verified by experiment. The results show that the simulation results are in good agreement with the experimental results. After SP compensation, the average output power of the coupling mechanism is 10.332 W, and the transmission efficiency is 69.84%, which can meet the requirements of contactless power supply for wireless monitoring nodes.
-
表 1 联合仿真参数值
Table 1. Co-simulation parameter values
参数 数值 参数 数值 Uin 15 V f 20 kHz Lp 94.962 μH Ls 75.557 μH M 52.039 μH RL 25 Ω Cp.ss 0.667 μF Cs.ss 0.838 μF Cp.sp 0.653 μF Cs.sp 0.838 μF 表 2 试验系统参数值
Table 2. Parameter values of test system
参数 数值 参数 数值 Uin 15 V f 20 kHz Lp 98 μH Ls 72 μH M 59.5 μH RL 25 Ω RLp 0.9 Ω RLs 0.8 Ω Cp.sp 0.625 μF Cs.sp 0.879 μF -
[1] WANG N, YUAN Z, WANG P. Dynamic electromagnetic force variation mechanism and energy loss of a non-contact loading device for a water-lubricated bearing[J]. Journal of Mechanical Science and Technology, 2021, 35(6): 2645-2656. doi: 10.1007/s12206-021-0535-y [2] OUYANG W, CHENG Q C, JIN Y, et al. Lubrication performance distribution of large aspect ratio water-lubricated bearings considering deformation and shaft bending[J]. Tribology Transactions, 2021, 64(4): 730-743. doi: 10.1080/10402004.2021.1913538 [3] 王楠, 杨利涛, 梁应选, 等. 非接触式电磁加载水润滑轴承监测系统[J]. 中国机械工程, 2019, 30(24): 3004-3009. https://www.cnki.com.cn/Article/CJFDTOTAL-ZGJX201924017.htmWANG N, YANG L T, LIANG Y X, et al. Non-contact electromagnetic loading monitoring system for water-lubricated bearings[J]. China Mechanical Engineering, 2019, 30(24): 3004-3009. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-ZGJX201924017.htm [4] 戚天博, 王楠, 杨利涛. 水润滑轴承水膜压力无线监测节点供电方法研究[J]. 中国测试, 2021, 47(2): 13-18. https://www.cnki.com.cn/Article/CJFDTOTAL-SYCS202102003.htmQI T B, WANG N, YANG L T. Research on power supply methods for wireless monitoring node of water-film pressure in water-lubricated bearing[J]. China Measurement & Test, 2021, 47(2): 13-18. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-SYCS202102003.htm [5] 王方哲, 朱永生, 闫柯, 等. 滚动轴承内圈温度无线监测技术[J]. 机械工程学报, 2018, 54(22): 8-14. https://www.cnki.com.cn/Article/CJFDTOTAL-JXXB201822002.htmWANG F Z, ZHU Y S, YAN K, et al. Wireless monitoring technology of rolling bearing inner ring temperature[J]. Journal of Mechanical Engineering, 2018, 54(22): 8-14. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-JXXB201822002.htm [6] ZHANG Y M, CHEN S X, LI X, et al. Design methodology of free-positioning nonoverlapping wireless charging for consumer electronics based on antiparallel windings[J]. IEEE Transactions on Industrial Electronics, 2022, 69(1): 825-834. doi: 10.1109/TIE.2020.3048322 [7] KATHIRVELU K P, SANDEEP G G V, SWATHI J, et al. Design of transformer for wireless power transfer in electric vehicles[J]. Iranian Journal of Science and Technology, Transactions of Electrical Engineering, 2021, 45(4): 1311-1324. doi: 10.1007/s40998-021-00441-w [8] 张献, 王杰, 杨庆新, 等. 电动汽车动态无线供电系统电能耦合机构与切换控制研究[J]. 电工技术学报, 2019, 34(15): 3093-3101. https://www.cnki.com.cn/Article/CJFDTOTAL-DGJS201915001.htmZHANG X, WANG J, YANG Q X, et al. The power coupling mechanism and switching control for dynamic wireless power supply system of electric vehicle[J]. Transactions of China Electrotechnical Society, 2019, 34(15): 3093-3101. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-DGJS201915001.htm [9] JIANG Y, CHEN K N, ZHAO Z M, et al. Designing an M-shape magnetic coupler for the wireless charging system in railway applications[J]. IEEE Transactions on Power Electronics, 2022, 37(1): 1059-1073. doi: 10.1109/TPEL.2021.3072248 [10] LUO B, LONG T, GUO L M, et al. Analysis and design of inductive and capacitive hybrid wireless power transfer system for railway application[J]. IEEE Transactions on Industry Applications, 2020, 56(3): 3034-3042. [11] 程为彬, 王洋, 康思民, 等. 井下定功率高效无线电能传输系统的分析与设计[J]. 电源学报, 2022, 20(2): 183-191. https://www.cnki.com.cn/Article/CJFDTOTAL-DYXB202202021.htmCHENG W B, WANG Y, KANG S M, et al. Analysis and design of downhole rated power and high efficiency wireless power transmission system[J]. Journal of Power Supply, 2022, 20(2): 183-191. (in Chinese) https://www.cnki.com.cn/Article/CJFDTOTAL-DYXB202202021.htm [12] XIN X Y, JACKSON D R, CHEN J. Wireless power transfer along oil pipe using ferrite materials[J]. IEEE Transactions on Magnetics, 2017, 53(3): 9200205. [13] WANG D A, CUI S M, BIE Z, et al. A redundancy design of wireless power transfer system for satellite slip ring with high reliability[C]//Proceedings of the IEEE 4th International Electrical and Energy Conference (CIEEC). Wuhan, China: IEEE, 2021: 1-6. [14] SONG K, MA B Q, YANG G, et al. A rotation-lightweight wireless power transfer system for solar wing driving[J]. IEEE Transactions on Power Electronics, 2019, 34(9): 8816-8830. [15] SOFIA A, TAVILLA A C, GARDENGHI R, et al. Power transfer for rotating medical machine[C]//Proceedings of the 38th Annual International Conference of the IEEE Engineering in Medicine and Biology Society (EMBC). Orlando, FL, USA: IEEE, 2016: 2137-2140.