转向制动工况下平衡重叉车横向稳定性控制

刘显贵; 姜梦平; 侯攀; 李颖新; 许超

doi:10.13433/j.cnki.1003-8728.20180058

转向制动工况下平衡重叉车横向稳定性控制

doi: 10.13433/j.cnki.1003-8728.20180058

1.
厦门理工学院机械与汽车工程学院, 福建厦门 361024;
2.
福建省客车及特种车辆研发协同创新中心, 福建厦门 361024;
3.
林德(中国)叉车有限公司, 福建厦门 361009

基金项目:

国家自然科学基金项目（51641507）与福建省科技创新平台项目（2016H2003）资助

详细信息

作者简介:
刘显贵(1973-),教授,硕士生导师,研究方向为车辆系统动力学等,2010110819@xmut.edu.cn

计量
- 文章访问数: 558
- HTML全文浏览量: 49
- PDF下载量: 282
- 被引次数: 0
出版历程
- 收稿日期: 2017-09-18
- 刊出日期: 2018-10-05

Lateral Stability Control of Counterbalanced Forklift under Braking and Steering Conditions

1.
School of Mechanical and Automotive Engineering, Xiamen University of Technology, Fujian Xiamen 361024, China;
2.
Fujian Collaborative Innovation Center for R & D of Coach and Special Vehicle, Fujian Xiamen 361024, China;
3.
Linde(China) Forklift Truck, Fujian Xiamen 361009, China

摘要

摘要: 为了克服实际叉车转向制动作业工况下质心位置的时变和动态行为不确定性导致整车侧倾，改善该工况下叉车的横向动态稳定性，建立了叉车制动转向工况半车动力学模型，以叉车横摆角速度和横向加速度为反馈控制量，设计了叉车主动后轮转向线性二次型调节器，得到最优输出反馈增益矩阵，对转向制动工况下的叉车横向稳定性进行最优控制并进行仿真计算。仿真结果表明，叉车制动性能保持基本不变的情况下，反映叉车横向稳定性的横向加速度和横摆角速度响应得到明显改善。依据欧洲标准EN16203：2012动态稳定性试验方法和要求进行的实车试验结果表明：叉车横向稳定性的指标量-横向加速度、横摆角速度均方根值分别下降了19.2%和23.29%，叉车的横向稳定性得到了有效控制。
- 平衡重叉车 /
- 制动 /
- 主动后轮转向系统 /
- 横向稳定性 /
- 控制
Abstract: In order to prevent rollover accidents and improve the lateral dynamic stability of the forklift under braking and steering conditions, the dynamic semi-model of forklift was built at first. Secondly the adaptive LQR control strategy is proposed in this paper, and the adaptive LQR controller of the active rear wheel steering system(ARS) is designed by the yaw rate and lateral acceleration as quadratic form indicators in order to overcome the time-varying position of mass center and uncertainties of dynamic behaviors caused by various forklift working conditions. The simulation was carried out in the braking and steering working conditions in MATLAB. The result of simulation shows that the lateral acceleration and yaw rate representing the lateral stability of forklifts are improved obviously in different working conditions and the lateral stability of forklift is also be enhanced significantly. The result of road test also shows that the root mean square values of the lateral acceleration and the yaw rate are reduced by 19.2% and 22.39% respectively, which improved the lateral dynamic stability of the counterbalanced forklift.
- counterbalanced forklift /
- brake /
- active rear wheel steering /
- lateral stability /
- control

HTML全文

参考文献(17)

[1]	刘显贵,何翠群,初长宝.基于CAN通讯的汽车底盘系统集成控制[J].农业工程学报,2010,26(7):163-168 Liu X G, He C Q, Chu C B. Integrated control of vehicle chassis system based on controller area network[J]. Transactions of the CSAE, 2010,26(7):163-168(in Chinese)
[2]	李君,喻凡,张建武,等.车辆转向制动防抱死系统仿真研究[J].系统仿真学报,2001,13(6):789-793 Li J, Yu F, Zhang J W, et al. An investigation into optimal target slip ratio control for simulation of an anti-lock braking system of vehicles[J]. Journal of System Simulation, 2001,13(6):789-793(in Chinese)
[3]	Esmailzadeh E, Goodarzi A, Vossoughi G R. Optimal yaw moment control law for improved vehicle handling[J]. Mechatronics, 2003,13(7):659-675
[4]	陈无畏,周慧会,刘翔宇.汽车ESP与ASS分层协调控制研究[J].机械工程学报,2009,45(8):190-96 Chen W W, Zhou H H, Liu X Y. Simulation research on layered coordinated control of automotive ESP and ASS[J]. Journal of Mechanical Engineering, 2009,45(8):190-196(in Chinese)
[5]	张代胜,李伟.基于滑移率的汽车防抱模糊控制方法与仿真[J].农业机械学报,2002,33(2):28-31 Zhang D S, Li W. Simulation for slip ratio of an automobile antilock-braking system based on fuzzy logic control method[J]. Transactions of the Chinese Society of Agricultural Machinery, 2002,33(2):28-31(in Chinese)
[6]	Fujimoto H, Tsumasaka A, Noguchi T. Direct yaw-moment control of electric vehicle based on cornering stiffness estimation[C]//Proceedings of the 31st Annual Conference of IEEE Industrial Electronics Society. Raleigh, NC, USA:IEEE, 2005:2626-2631
[7]	Bjoern A. Modeling and control of a superimposed steering system[D]. Atlanta:Georgia Institute of Technology, 2004:3-4
[8]	Elbeheiry E M, Zeyada Y F, Elaraby M E. Handling capabilities of vehicles in emergencies using coordinated AFS and ARMC systems[J]. Vehicle System Dynamics, 2001,35(3):195-215
[9]	曾昭茂,袁翔,何三全,等.叉车制动方向稳定性分析与研究[J].工程机械,1999,(2):3-7 Zeng Z M, Yuan X, He S Q, et al. Analysis and study in the directional stability of forklift during braking[J]. Construction Machinery and Equipment, 1999,(2):3-7(in Chinese)
[10]	夏光,陈无畏,唐希雯,等.平衡重式叉车底盘神经网络逆系统解耦控制[J].中国工程机械学报,2014, 12(5):384-390 Xia G, Chen W W, Tang X W, et al. Decoupling control on neutral network inverse system for counterbalanced forklift chassis[J]. Chinese Journal of Construction Machinery, 2014,12(5):384-390(in Chinese)
[11]	夏光,陈无畏,赵林峰,等.平衡重式叉车底盘小波网络动态逆内模控制[J].机械工程学报,2015,51(18):126-135 Xia G, Chen W W, Zhao L F, et al. Integrated control of counterbalanced forklift truck chassis based on wavelet network dynamic inverse internal model control[J]. Journal of Mechanical Engineering, 2015,51(18):126-135(in Chinese)
[12]	余绍华,任家权.叉车主动式稳定系统研究[J].物流技术与应用,2013,(8):125-129 Yu S H, Ren J Q. Study on active stability system of forklift truck[J]. Logistics & Material Handling, 2013,(8):125-129(in Chinese)
[13]	陈德玲,陈俐,殷承良.制动过程的主动转向干预控制[J].系统仿真学报,2008,20(10):2640-2645 Chen D L, Chen L, Yin C L. Active front steering intervention control during braking[J]. Journal of System Simulation, 2008,20(10):2640-2645(in Chinese)
[14]	Hac A, Doman D, Oppenheimer M. Unified control of brake and steer-by-wire systems using optimal control allocation methods[C]//SAE 2006 World Congress & Exhibition. Michigan, USA:Society of Automotive Engineers, 2006
[15]	Pacejka H B, Besselink I J M. Magic formula tyre model with transient properties[J]. Vehicle System Dynamics, 1997,27(S1):234-249
[16]	Jiang L, Wang X Y, Masao N. Integrated control for vehicle yaw motion using double-cost-function LQR[J]. Chinese Journal of Mechanical Engineering, 2000,13(3):228-233
[17]	EN16203:2012 Safety of industrial trucks-verification of dynamic stability-counterbalanced trucks[S]