发动机进气歧管的气动噪声预测方法研究

徐志超; 祖炳锋; 王振; 徐玉梁; 刘丽娜; 白杨

doi:10.13433/j.cnki.1003-8728.20180008

发动机进气歧管的气动噪声预测方法研究

doi: 10.13433/j.cnki.1003-8728.20180008

徐志超^1,2,
祖炳锋^1,2, ,,
王振¹,
徐玉梁^1,2,
刘丽娜¹,
白杨¹

1.
天津大学内燃机研究所, 天津 300072;
2.
天津大学机械工程学院, 天津 300072

基金项目:

国家重点基础研究发展计划项目（2013CB228400）资助

详细信息

作者简介:
徐志超(1992-),硕士研究生,研究方向为振动与噪声分析,xuzhichao@tju.edu.cn

通讯作者:
祖炳锋,研究员,博士,zbf@tju.edu.cn

计量
- 文章访问数: 918
- HTML全文浏览量: 51
- PDF下载量: 639
- 被引次数: 0
出版历程
- 收稿日期: 2017-07-28
- 刊出日期: 2018-08-05

Prediction Method Research of Aerodynamic Noise for Engine Intake Manifold

Xu Zhichao^1,2,
Zu Bingfeng^{1,2
, ,},
Wang Zhen¹,
Xu Yuliang^1,2,
Liu Li'na¹,
Bai Yang¹

1.
Internal Combustion Engine Research Institute, Tianjin University, Tianjin 300072, China;
2.
School of Machinery, Tianjin University, Tianjin 300072, China

摘要

摘要: 为更加准确预测发动机进气噪声，发展了采用瞬态边界计算进气歧管流场的方法，并联合声学软件进行声场预测。从一维仿真模型获得可靠的压力和速度边界用于流场计算；采用大涡模拟（LES）和分离涡模拟（DES）两种求解算法模拟歧管内的流场；通过声学有限元方法计算进气口辐射的气动噪声。LES和DES两种方法的流场结果对比表明，DES结果与LES非常接近，同时耗时更少；声场结果与实验结果吻合较好，证明了本文预测方法的准确性；模拟结果和压力边界频谱图的对比分析使空滤器和进气歧管设计更具针对性。
- 进气噪声 /
- 瞬态边界 /
- 声学特性分析
Abstract: In order to predict the engine intake noise accurately, transient analysis is used in aero-acoustics calculations of intake manifold flow, and the acoustics field distribution is simulated in acoustics software. Establish a one-dimensional engine model which is calibrated by experimental data to output reliable pressure and velocity results for flow field calculation. Two turbulence models, the large eddy simulation (LES) and detached eddy simulation (DES) methods are used separately to simulate the flow field in the manifold accurately. The aerodynamics noise is calculated by acoustic FEM method using surface pressure distribution. Comparisons between two algorithms indicate that DES can get results of similar accuracy with LES while DES using less time. The results are compared with NVH test data and the accuracy of simulation method is verified. The spectrum analysis between simulation results and pressure boundary in frequency domain make the design of vacuum filter and intake manifold more specific.
- intake noise /
- transient analysis /
- turbulence models

HTML全文

参考文献(15)

[1]	Suzuki T, Kayaba F. The analysis and mechanism of engine ‘Intake Rumbling Noise’[J]. SAE Transactions, 1990:2059-2067
[2]	Davies P O A L, Holland K R. I.C. Engine intake and exhaust noise assessment[J]. Journal of Sound and Vibration, 1999,223(3):425-444
[3]	孙济美,牟永泉,董愚,等.发动机模型进气道内气体流场的模拟和实验研究[J].内燃机学报,1989,7(2):117-123 Sun J M, Mu Y Q, Dong Y, et al. An investigation of the flow field in the model intake port of engine with simulation and experimental methods[J]. Transactions of CSICE, 1989,7(2):117-123(in Chinese)
[4]	Low S C, Feng M. Prediction of pressure fluctuation in the inlet and exhaust system of engine using a real gas model[R]. SAE Technical Papers, 2001
[5]	Kim J, Kang K T, Yeo S D. A study on mechanism of intake rumble noise and optimization of intake manifold[C]//Proceedings of INTER-NOISE and NOISE-CON Congress and Conference Proceedings. The Hague, The Netherlands:Institute of Noise Control Engineering, 2001:1231-1234
[6]	刘亚茹.车用涡轮增压器噪声机理研究[D].北京:北京理工大学,2015 Liu Y R. Research on noise mechanism of vehicle turbocharger[D]. Beijing:Beijing Institute of Technology, 2015(in Chinese)
[7]	梁志成.用分离涡方法对梢涡流动的数值模拟[D].上海:上海交通大学,2012 Liang Z C. Detached-eddy simulation of wing-tip vortex[D]. Shanghai:Shanghai Jiaotong University, 2012(in Chinese)
[8]	Spalart P R, Jou W H, Strelets M, et al. Comments on the feasibility of LES for wings, and on a hybrid RANS/LES approach[C]//Proceedings of the 1st AFOSR International Conference on DES/LES. Columbus, OH:Greyden Press, 1997
[9]	朱远征,左言言,华敏相,等.虚拟激励法的汽车气动噪声研究[J].机械科学与技术,2017,36(4):626-631 Zhu Y Z, Zuo Y Y, Hua M X, et al. Study on automobile aerodynamic noise based on pseudo-excitation method[J]. Mechanical Science and Technology for Aerospace Engineering, 2017,36(4):626-631(in Chinese)
[10]	Spalart P R, Deck S, Shur M L, et al. A new version of detached-eddy simulation, resistant to ambiguous grid densities[J]. Theoretical and Computational Fluid Dynamics, 2006,20(3):181-195
[11]	Shur M L, Spalart P R, Strelets M K, et al. A hybrid RANS-LES approach with delayed-DES and wall-modelled LES capabilities[J]. International Journal of Heat and Fluid Flow, 2008,29(6):1638-1649
[12]	Williams J E F, Hawkings D L. Sound generation by turbulence and surfaces in arbitrary motion[J]. Philosophical Transactions for the Royal Society A:Mathematical and Physical Sciences, 1969,264(1151):321-342
[13]	徐俊伟,吴亚锋,陈耿.气动噪声数值计算方法的比较与应用[J].噪声与振动控制,2012,32(4):6-10 Xu J W, Wu Y F, Chen G. Comparison and application on the aero-acoustics numerical computing methods[J]. Noise and Vibration Control, 2012,32(4):6-10(in Chinese)
[14]	徐红梅,郝志勇,郭磊.阶次分析在发动机进气噪声研究中的应用[J].小型内燃机与摩托车,2008,37(1):83-86 Xu H M, Hao Z Y, Guo L. Application of order analysis in intake noise research of engine[J]. Small Internal Combustion Engine and Motorcycle, 2008,37(1):83-86(in Chinese)
[15]	岳贵平,卢炳武,刘英杰,等.发动机进气系统声学元件设计方法研究[J].汽车技术,2009,(10):12-15 Yue G P, Lu B Q, Liu Y J, et al. Study of design method of acoustic components of engine's intake systems[J]. Automobile Technology, 2009,(10):12-15(in Chinese)