假人腰椎动态冲击特性的试验研究

颜凌波; 杨冲; 彭凯; 戴宏亮; 曹立波

doi:10.13433/j.cnki.1003-8728.2018.0319

假人腰椎动态冲击特性的试验研究

doi: 10.13433/j.cnki.1003-8728.2018.0319

1.
湖南大学汽车车身先进设计制造国家重点实验室, 长沙 410082;
2.
汽车噪声振动和安全技术国家重点实验室, 重庆 400039

基金项目:

国家自然科学基金项目（51605152）、湖南大学汽车车身先进设计制造国家重点实验室开放基金项目（31575005）及汽车噪声振动和安全技术国家重点实验室2015年度开放基金项目（NVHSKL-201509）资助

详细信息

作者简介:
颜凌波(1984-),助理研究员,博士,研究方向为汽车被动安全及力学损伤假人设计,milanylb@hotmail.com

计量
- 文章访问数: 154
- HTML全文浏览量: 30
- PDF下载量: 4
- 被引次数: 0
出版历程
- 收稿日期: 2017-01-26
- 刊出日期: 2018-03-05

Experimental Study on Dynamic Impact Mechanical Properties of Dummy Lumbar Spine

1.
State Key Laboratory of Advanced Design and Manufacturing for Vehicle Body, Hunan University, Changsha 410082, China;
2.
State Key Laboratory of Vehicle NVH and Safety Technology, Chongqing 400039, China

摘要

摘要: 基于假人腰椎在台车试验中的弯曲响应曲线，设计了针对单独假人腰椎部件的动态冲击弯曲试验装置，并进行了多次动态冲击试验，得到了腰椎橡胶邵氏硬度对腰椎力学特性的影响规律。研究结果表明，自行设计的动态冲击试验装置可较好地反映腰椎在台车碰撞中的动态冲击特性，试验装置具有操作简单，重复性好的特点；在同等动态冲击试验下，假人腰椎橡胶硬度和腰椎冲击弯角峰值呈负相关的线性关系，橡胶硬度每升高一度，腰椎弯角峰值约下降0.56°。
- 假人腰椎 /
- 试验装置 /
- 力学特性 /
- 动态冲击
Abstract: Based on the bending response curve of the lumbar spine in the sled test, a dynamic impact bending test device for dummy lumbar spine was designed and the dynamic impact test was conducted. The influence of the Shore hardness of lumbar rubber on the mechanical properties of lumbar spine was investigated. Results showed that the dynamic impact test device can reflect the dynamic impact mechanics of the lumbar spine in the sled test. The test device has the advantages of simple operation and good repeatability. Under the same dynamic impact test, there is a negative linear relationship between the hardness and the peak value of dynamic bending angle. It is indicated that when the rubber hardness increased one degree, the peak value of lumbar bending angle decreased about 0.56°.
- dummy lumbar spine /
- design /
- test device /
- dynamic response

HTML全文

参考文献(15)

[1]	Schneider L W, Haffner M P, Eppinger R H, et al. Development of an advanced ATD thorax system for improved injury assessment in frontal crash environments[R]. SAE Technical Paper 922550, 1992
[2]	张金换,杜汇良,马春生,等.汽车碰撞安全性设计[M].北京:清华大学出版社,2010 Zhang J H, Du H L, Ma C S, et al. Automotive design for crash safety[M]. Beijing:Tsinghua University Press, 2010(in Chinese)
[3]	Foster J K, Kortge J O, Wolanin M J. Hybrid Ⅲ-a biomechanically-based crash test dummy[R]. SAE Technical Paper 770938, 1977
[4]	Nahum A M, Melvin J W. Accidental injury:biomechanics and prevention[M]. 2nd ed. New York:Springer, 2002:457-457
[5]	Stammen J A, Herriott R, Kang Y S, et al. Dynamic properties of the Upper Thoracic Spine-Pectoral Girdle (UTS-PG) system and corresponding kinematics in PMHS sled tests[R]. SAE Technical Paper 2012-22-0003, 2012
[6]	贝广常,谢发勤,姚小飞,等.橡胶老化及其防护技术的研究概况[J].橡胶工业,2013,60(1):58-61 Bei G C, Xie F Q, Yao X F, et al. Research on aging and protection technology of rubber[J]. China Rubber Industry, 2013,60(1):58-61(in Chinese)
[7]	Wood G W, Panzer M B, Bass C R, et al. Viscoelastic properties of hybrid ⅢⅡ head skin[J]. SAE International Journal of Materials and Manufacturing, 2010,3(1):186-193
[8]	刘栋.汽车正面碰撞试验用假人标定系统的研究[D].成都:四川大学,2004 Liu D. Research of the automobile obverse impacting dummy calibration system[D]. Chengdu:Sichuan University, 2004(in Chinese)
[9]	国家质量监督检验检疫总局. JJF 1230-2009汽车正面碰撞试验用人形试验装置校准规范[S].北京:中国计量出版社,2009 General Administration of Quality Supervision, Inspection and Quarantine. JJF1230-2009 Calibration specification of the anthropomorphic test device in vehicle frontal collision test[S]. Beijing:China Metrology Publishing House, 2009(in Chinese)
[10]	王凯,李向荣,朱海涛,等.Hybrid Ⅲ 50百分位假人胸部低速撞击标定研究[J].汽车工程,2009,31(2):1123-1125,1132 Wang K, Li X R, Zhu H T, et al. A research on the calibration of low speed impact on the thorax of Hybrid Ⅲ 50th percentile dummy[J]. Automotive Engineering, 2009,31(12):1123-1125,1132(in Chinese)
[11]	许述财,杨欣,赖兴华,等.假人颈部标定试验台设计与验证[J].清华大学学报(自然科学版),2013,53(2):174-178,199 Xu S C, Yang X, Lai X H, et al. Design and validation of a dummy neck pendulum test fixture[J]. Journal of Tsinghua University (Science & Technology), 2013,53(2):174-178,199(in Chinese)
[12]	任建英,朱政.汽车正碰试验假人头部与颈部标定试验研究[J].机械设计与制造,2009,(7):166-168 Ren J Y, Zhu Z. Test research on head and neck calibration of the dummies used in vehicle frontal crash test[J]. Machinery Design & Manufacture, 2009,(7):166-168(in Chinese)
[13]	张恺,颜凌波,杜现平,等.假人脚部力学特性的试验研究[J].机械科学与技术,2015,34(8):1279-1282 Zhang K, Yan L B, Du X P, et al. Experimental study on mechanical characteristics of dummy foot[J]. Mechanical Science and Technology for Aerospace Engineering, 2015,34(8):1279-1282(in Chinese)
[14]	Humanetics Innovation Solutions. HⅢ 50th lumbar bend test[R]. USA, 2013
[15]	Dummy Testing and Equipment Committee. J2856_200909 User's Manual for the 50th percentile male hybrid Ⅲ T dummy[S]. USA:SAE International, 2009