DAI Yue, REN Chong, FANG Wei-xin. Design of the FDM Scanning Mode Based on ANSYS[J]. International Journal of Plant Engineering and Management, 2014, 19(4): 251-254

Design of the FDM Scanning Mode Based on ANSYS
DAI Yue, REN Chong, FANG Wei-xin
Inner Mongolia University of Science & Technology, Baotou 014010, P.R.Chinese
Fused deposition rapid prototyping is an important technology of rapid prototyping. In order to improve the processing technology,the process plan to change its scanning mode is put forward,through the finite element simulation. The verification in the accumulation of fewer layers change the long and short side scanning to improve the rationality of fused deposition rapid prototyping. Based on the ANSYS version of the classic Gauss heat source on the use of mobile technology,it is reasonable to describe the formation process of fused deposition rapid prototyping,and put forward the improvement scheme is put forward.
Key words:    rapid prototyping    FDM Process    ANSYS    gaussian heat moving source    scanning mode   
Received: 2014-11-10     Revised:
DOI: 10.13434/j.cnki.1007-4546.2014.0410
Corresponding author:     Email:
Author description:
PDF(234KB) Free

[1] Fan L R. Uniform wall FDM technology in rapid prototyping technology research method based on thick filled [D]. Baotou: Inner Mongolia University of Science and Technology,2011 (in Chinese)
[2] Pei L, Wu R D,Zhang J,et al. Scanning speed on fused deposition forming finite element analysis of the effect of [J]. China Mechanical Engineering, 2003, (8):687-690 (in Chinese)
[3] Zhang H C. Where the wave.ANSYS13.0 from entry to the actual[M]. Beijing: Mechanical Industry Press, 2011
[4] Chen J. FDM scanning mode of[D]. Wuhan: Huazhong University of Science and Technology,2009 (in Chinese)
[5] Gurr M,Thomann Y,Nedelcu M,et al. Novel acrylic nanocomposites constaining in-situ formed calcium phosphate/layered silicate hybrid nanoparticles for photochemical rapid prototyping, rapid tooling and rapid manufacturing processes[J].Polymer, 2010, (51):5058-5070
Similar articles:
1.PANG Xue-qin, REN Chong, HAN Lei-gang.Effect of Molding Material Temperature on Workpiece in FDM[J]. International Journal of Plant Engineering and Management, 2015,20(3): 170-178