|
|
论文:2015,Vol:33,Issue(6):994-1000 |
|
|
引用本文： |
|
|
相里康, 马瑞卿, 张庆超, 韩伟健, 邓钧君. 飞机电刹车系统电磁干扰产生机理及抑制方法[J]. 西北工业大学学报 |
|
|
Xiangli Kang, Ma Ruiqing, Zhang Qingchao, Han Weijian, Deng Junjun. Mechanism for Electro-Magnetic Interference in an Aircraft's Electric Braking System and Its Suppression Method[J]. Northwestern polytechnical university |
|
|
|
|
|
|
|
| 飞机电刹车系统电磁干扰产生机理及抑制方法 |
|
| 相里康, 马瑞卿, 张庆超, 韩伟健, 邓钧君 |
|
| 西北工业大学 自动化学院, 陕西 西安 710072 |
| 摘要: |
| 针对飞机电刹车系统力传感器信号上叠加有高幅干扰这一问题,通过对电刹车系统分析,认为电机三相电流以及机电作动控制器(EMAC)输出PWM波为主要干扰源,电缆线路之间的耦合干扰是造成干扰的主要原因。建立了线路耦合干扰的数学模型,并据此采用电磁屏蔽、线路绞合和有效接地来减少线路耦合,并在EMAC输出端设计了无源EMI滤波器。通过这些改进,极大地减弱了干扰,提高了系统电磁兼容性,保证了刹车力伺服系统正常工作。 |
| 关键词:
飞机
电刹车系统
电磁干扰
传输电缆
EMI滤波器
|
|
| Mechanism for Electro-Magnetic Interference in an Aircraft's Electric Braking System and Its Suppression Method |
|
| Xiangli Kang, Ma Ruiqing, Zhang Qingchao, Han Weijian, Deng Junjun |
|
| Department of Automation Control, Northwestern Polytechnical University, Xi'an 710072, China |
| Abstract: |
| This paper deals with the problem that the signals of the force sensor of an aircraft's electric braking system are superimposed with high-amplitude interference. The analysis of the electric braking system shows that the three-phase current of its motor and the pulse width modulation (PWM) wave output by the electro-mechanical actuator controller (EMAC) are the primary sources of interference and that the coupling interference between cable lines is the main cause of the interference of signals of the force sensor. The mathematical model of coupling interference between cable lines is established, according to which the transmission cable is designed and the line coupling was reduced by using electromagnetic shielding, line twisting and effective grounding. A passive electromagnetic interference (EMI) filter is designed for the output end of the EMAC. Through these improvements, the interference superimposed on the force sensor is greatly reduced. The paper also improves the electromagnetic compatibility of the electric braking system and ensures that the braking force servo system works normally. |
| Key words:
aircraft
braking
brushless DC motors
design
design of experiments
efficiency
electromagnetic shielding
fast Fourier transforms
interference suppression
mathematical models
pulse width modulation
sensors
schematic diagrams
topology
electric braking system
electromagnetic interference (EMI)
EMI filter
transmission cable
|
|
| 收稿日期: 2015-04-24
修回日期:
|
| DOI: |
| 通讯作者:
Email： |
| 作者简介: 相里康(1988—),西北工业大学博士研究生,主要从事飞机全电刹车系统及其关键技术的研究。
|
|
|
|
|
|
|
|
参考文献: |
|
|
[1] 李洪果,王锴,吴瑞祥,等. 飞机全电刹车系统研究[J]. 北京航空航天大学学报,2004,30(4):339-343 Li Hongguo, Wang Kai, Wu Ruixiang, et al. Demonstration of an Plane Electrically Actuated Brake[J]. Journal of Beijing University of Aeronautics and Astronautics, 2004,30(4):339-343 (in Chinese)
[2] Hirofumi Akagi, Takayuki Shimizu. Attenuation of Conducted EMI Emissions From an Inverter-Driven Motor[J]. IEEE Trans on Power Electronics, 2008, 23(1): 282-290
[3] 汪泉弟,刘青松,安宗裕,等. 混合动力客车低频电磁辐射机理及抑制方法[J]. 电工技术学报,2014,29(1):202-207 Wang Quandi, Liu Qingsong, An Zongyu, et al. Electromagnetic Radiation Mechanism and Noise Suppression Method for Hybrid Electric Bus[J]. Transactions of China Electrotechnical Society, 2014, 29(1): 202-207 (in Chinese)
[4] Olsen R G. A Simple Model for Weakly Coupled Lossy Transmission Lines of Finite Length[J]. IEEE Trans on Electromagnetic Compatibility, 1984, 26(2): 79-83
[5] Cory H, Shiran S. The Importance of Losses in the Coupling of Transmission Lines[J]. IEEE Trans on Electromagnetic Compatibility, 1988, 30(4): 567-570
[6] Tesche F M, Ianoz M V, Karlsson T. EMC Analysis Methods and Computational Models[M]. Wiley Interscience, New York, 1997: 90-91
[7] 刘帆,陈柏超,卞利钢. 变电站二次电缆屏蔽层接地方式探讨[J]. 电网技术,2003(02):63-67 Liu Fan, Chen Baichao, Bian Ligang. Discussion on Shielded Grounding Mode of Cables in Secondary Circuits of Substations[J]. Power System Technology, 2003(02): 63-67 (in Chinese)
[8] Akagi H, Shimizu T. Attenuation of Conducted EMI Emissions from an Inverter-Driven Motor[J]. IEEE Trans on Power Electronics, 2008,23(1): 282-290 |
|
|
|
|
|
|
|
