|
|
论文:2015,Vol:33,Issue(3):456-461 |
|
|
引用本文： |
|
|
王治武, 张昆, 郑龙席, 卢杰, 张洋. 喷管角度对脉冲爆震发动机性能影响数值研究[J]. 西北工业大学学报 |
|
|
Wang Zhiwu, Zhang Kun, Zheng Longxi, Lu Jie, Zhang Yang. Numerical Simulation of the Nozzle Angle Effect on PDE Performance[J]. Northwestern polytechnical university |
|
|
|
|
|
|
|
| 喷管角度对脉冲爆震发动机性能影响数值研究 |
|
| 王治武, 张昆, 郑龙席, 卢杰, 张洋 |
|
| 西北工业大学 动力与能源学院, 陕西 西安 710072 |
| 摘要: |
| 为了研究喷管角度对脉冲爆震发动机性能的影响,以丙烷和空气分别为燃料和氧化剂,对采用不同收敛角和扩张角喷管的脉冲爆震发动机工作过程进行了单循环数值模拟。研究结果表明,收敛喷管的收敛角和扩张喷管的扩张角对脉冲爆震发动机性能的影响规律是不同的。收敛喷管出口要比扩张喷管出口更早地形成膨胀波系,扩张喷管出口膨胀得要比收敛喷管出口膨胀得更为充分。对于收敛喷管而言,无论收敛角度如何变化,都会有正的推力增益;对于扩张喷管,当扩张角度超过9°时,就会产生负的推力增益。喷管收敛角为9°时的脉冲爆震发动机性能较好。 |
| 关键词:
脉冲爆震发动机
喷管
数值模拟
收敛角
扩张角
|
|
| Numerical Simulation of the Nozzle Angle Effect on PDE Performance |
|
| Wang Zhiwu, Zhang Kun, Zheng Longxi, Lu Jie, Zhang Yang |
|
| Department of Aero-Engines, Northwestern Polytechnical University, Xi'an 710072, China |
| Abstract: |
| In order to investigate the effects of nozzles with different angles on PDE performance, PDE with nozzles of different convergent and divergent angles was simulated and propane-air mixture was used. The simulation results indicated that the effects of nozzles with different angles on PDE performance were not the same. While a series of expansion wave appeared earlier in the outlet of the convergent nozzle, the gas expanded perfect in the outlet of the divergent nozzle. For the PDE with convergent nozzle, the thrust augmentation was always positive no matter how the convergent angle changed. For the PDE with a divergent nozzle, there was a thrust loss with a divergent angle of over 9°. When the nozzle convergent angle was 9°,PDE obtained the highest performance. |
| Key words:
Pulse detonation engines
Nozzle
Compute Simulation
Convergent angle
Divergent angle
|
|
| 收稿日期: 2014-10-30
修回日期:
|
| DOI: |
| 基金项目: 国家自然科学基金(51306153>91441201)、国家留学基金、陕西省自然科学基金(2014JM7256)、高等学校博士学科点专项科研基金新教师资助课题(20116102120027)与中央高校基本科研业务专项项目(31020152737)资助 |
| 通讯作者:
Email： |
| 作者简介: 王治武(1981—),西北工业大学副教授,主要从事燃烧学及流体力学研究。
|
|
| 相关功能 |
|
|
|
|
| 作者相关文章 |
|
| 王治武 在本刊中的所有文章 |
| 张昆 在本刊中的所有文章 |
| 郑龙席 在本刊中的所有文章 |
| 卢杰 在本刊中的所有文章 |
| 张洋 在本刊中的所有文章 |
|
|
|
|
|
|
|
|
参考文献: |
|
|
[1] 严传俊, 范玮. 脉冲爆震发动机原理及关键技术[M]. 西安:西北工业大学出版社, 2005 Yan Chuanjun, Fan Wei. Principle and Key Technology of Pulse Detonation Engine[M]. Xi'an: Northwestern Polytechnical University Press, 2005
[2] Stuessy W S, Wilson D R. Experimental Investigation of an Annular Multi-Cycle Pulse Detonation Wave Engine[R]. AIAA-1997-0080
[3] Zitoun R, Desbordes D. ProPulsive Performances of Pulse Detonations[J]. Combustion Science and Technology, 1999, 144(1): 93-114
[4] Daniau D, Zitoun R, Couquet C, et al. Effeets of Nozzles of Different Length and Shape on the Propulsion Performance of Pulse Detonation Engines.//High Speed Deflagration and Detonation, Fundamentals and Control[M]. Edited by Roy G Frolov S, Netzer D, Borisov. Moseow, Russia: ELEX-KM Publishes, 2001
[5] CooPer M, Jaekson S, Austin J, et al. Direct Experimental Impulse Measurements for Detonations and Deflagrations[R]. AIAA-2001-3812
[6] Allgood D, Gutmark E, Hoke J, et a1. Performance Measurements of Multi-Cycle Pulse Detonation Engine Exhaust Nozzles[R]. AIAA-2005-0222
[7] 范玮, 严传俊, 李强, 胡承启, 叶斌. 脉冲爆震发动机尾喷管实验[J]. 航空动力学报, 2007, 23(6): 869-872 Fan Wei, Yan Chuanjun, Li Qiang, Hu Chengqi, Ye Bin. Experiment of Pulse Detonation Engine Jet Nozzle[J]. Aerospace Power, 2007, 23(6): 869-872 (in Chinese)
[8] 王治武, 严传俊, 黄希桥, 熊姹涂, 洪妍. 吸气式脉冲爆震发动机喷管试验研究[J]. 工程热物理学报, 2008, 29(12): 2011-2014 Wang Zhiwu, Yan Chuanjun, Huang Xiqiao, Xiong Chatu, Hong Yan. Experiment of Air Breathing Pulse Detonation Engine Jet Nozzle[J]. Journal of Engineering Thermophysics, 2008, 29(12): 2011-2014
[9] Yungster S. Analysis of Nozzle Effects on Pulse Detonation Engine Performance[R]. AIAA-2003-1316
[10] 李辉煌, 杨基明, 徐立功. 脉冲爆震发动机喷管流动的数值模拟[J]. 推进技术, 2004, 25(6): 553-556 Li Huihuang,Yang Jiming,Xu Ligong. A Numerical Simulation on the Nozzle Flow of Pulse Detonation Engine[J]. Journal of Propulsion Technology, 2004, 25(6): 553-556 (in Chinese)
[11] Venkat E T, Anthony J D, et al. Performance of a Pulse Detonation Engine under Subsonic and Supersonic Flight Conditions[R]. AIAA-2007-1245
[12] 李强, 范玮, 严传俊. 脉冲爆震火箭发动机收敛扩张喷管数值模拟[J]. 北京航空航天大学学报, 2007, 33(7): 789-792 Li Qiang. Fan Wei, Yan Chuanjun. Numerical Simulation of Pulse Detonation Rocket Engine Convergent-Divergent Nozzle[J]. Journal of Beijing University of Aeronautics and Astronautics, 2007, 33(7): 789-792 (in Chinese)
[13] 曾昊, 何立明, 章雄伟, 罗俊, 于锦禄. 喷管结构形式对爆震发动机性能影响分析[J]. 应用力学学报, 2010, 27(4): 650-655 Zeng Hao, He Liming, Zhang Xiongwei, Luo Jun, Yu Jinlu. Investigation on the Effects of Nozzle Structures on PDE Performance[J]. Journal of Applied Mechanics, 2010, 27(4): 650-655 (in Chinese)
[14] 曾昊, 何立明, 章雄伟, 罗俊. 喷管收敛-扩张角对爆震发动机性能影响分析[J]. 推进技术, 2011, 32(1): 97-102 Zeng Hao,He Liming,Zhang Xiongwei,Luo Jun. Investigation on the Effects of Nozzles with Different Convergent-Divergent Angle on PDE Performance[J]. Journal of Propulsion Technology, 2011, 32(1): 97-102 (in Chinese)
[15] 李宜敏, 张中钦, 张远君. 固体火箭发动机原理[M]. 北京:北京航空航天大学出版社, 1991 Li Yimin, Zhang Zhongqin, Zhang Yuanjun. Principle of Solid Rocket Engine[M]. Beijing:Beijing University of Aeronautics and Astronautics Press, 1991 (in Chinese) |
|
|
|
相关文献: |
|
|
1．张乐, 周洲, 许晓平, 王红波.飞翼无人机保形进排气系统动力数值模拟与流场特性分析[J]. 西北工业大学学报, 2015,33(3): 353-360 |
|
|
2．郑龙席, 卢杰, 彭畅新, 王治武.吸气式无阀脉冲爆震发动机DDT过程数值模拟[J]. 西北工业大学学报, 2014,32(5): 713-718 |
|
|
3．李林, 胡春波, 邓哲, 李佳明.喷管尺寸对火箭发动机喷流噪声影响研究[J]. 西北工业大学学报, 2013,31(3): 345-349 |
|
|
4．张乐, 周洲, 李盈盈, 甘文彪, 许晓平.飞翼无人机保形非对称尾喷管设计与流场特性[J]. 西北工业大学学报, |
|
|
|
|
|
|
