Fatigue Life Analysis of Hydro-mechanical Continuously Variable Transmission Box of Heavy Tractor
-
摘要: 针对重型拖拉机液压机械无级变速器(简称HMCVT)实际作业过程中由于箱体受载复杂,载荷不对称从而易发生疲劳破坏的问题。本文提出了一种基于虚拟样机技术修正材料S-N曲线对HMVCT箱体进行疲劳寿命预测的方法。利用Adams建立变速器刚柔耦合虚拟样机模型,提取HMCVT箱体各轴承孔处的动态激励。综合考虑HMCVT箱体载荷特点,结构参数,表面工艺等因素,重新拟合了箱体结构S - N曲线,根据Miner线性累计损伤理论对HMCVT箱体进行疲劳寿命预测。结果表明,结构S - N曲线较传统材料S - N曲线有较大程度的修正,HMCVT箱体危险点疲劳累计损伤量为D = 4.8353×10−8,变速箱寿命为57447 h,满足全寿命使用要求。该研究为设计及优化农机装备关键零部件时的疲劳寿命预测提供了参考。
-
关键词:
- HMCVT箱体 /
- 刚柔耦合虚拟样机模型 /
- 动态激励 /
- 线性累积损伤 /
- 疲劳寿命
Abstract: In order to solve the fatigue failure problem of the hydro-mechanical continuously variable transmission(HMCVT) boxof the heavy tractor due to the complex load in the actual process, a fatigue life prediction method for HMCVT box based on the virtual prototype technology was proposed. A rigid-flexible coupling virtual prototype model for HMCVT box was established based on Adams. Besides, the dynamic excitation of each bearing hole of gearbox shell under different working conditions was acquired. S - N curves of HMCVT boxwere re-fitted under the consideration of load characteristics, structure parameters, and surface technology. Finally, the prediction offatigue life of the HMCVT boxwas conducted based on the Miner linear accumulative damage theory. The results indicated that the S - N curve of the structure has a certaindegreeof modification comparing with the traditional material. The dangerous point of the shell was located at the bore of the idler axle under the dynamic excitation, while the fatigue cumulative damage (D) was 4.8353×10−8, and the life of the HMCVT box is 57447 hours. So, the structure design of the box was conservative and satisfied the requirement of service time. -
表 1 变速器扭矩负载
拖拉机作业方式 路面负载/Nm 变速箱输出轴扭矩/Nm 运输工况 3 969 148 犁耕工况 20 844 775 表 2 各轴承孔载荷最大值
轴承孔 X方向/N Y方向/N Z方向/N 犁耕工况 运输工况 犁耕工况 运输工况 犁耕工况 运输工况 Ⅰ 轴 左 13 780 5 140 11 759 −6 354 9 668 6 086 右 −3 573 −1 551 15 673 −4 639 −8 529 −4 761 Ⅱ 轴 左 3 206 −4 266 −5 576 −3 984 3 489 2 155 右 −23 829 −19 880 12 230 7 467 8 338 7 052 Ⅲ 轴 左 6 055 7 493 6 155 3 933 4 125 1 600 右 14 454 9 207 24 956 12 907 −5 102 −3 713 Ⅳ 轴 左 −53 329 −26 677 −56 354 −54 011 −22 179 −6 800 右 56 036 40 632 −51 837 32 138 −30 831 13 520 Ⅴ 轴 左 −28 459 −15 682 9 473 3 878 17 571 9 380 右 −56 835 −35 001 50 595 22 756 −26 239 −20 311 Ⅵ 轴 左 −30 638 30 180 −45 253 36 446 14 858 10 601 右 45 376 −1 551 15 673 −4 639 −8 529 −4 761 -
[1] 张高峰, 尤强强, 王文. 基于动态啮合刚度的变速箱动态响应特性研究[J]. 机械传动, 2018, 42(7): 81-86ZHANG G F, YOU Q Q, WANG W. Research of the dynamic response characteristic of transmission system based on dynamic meshing stiffness[J]. Journal of Mechanical Transmission, 2018, 42(7): 81-86 (in Chinese) [2] 孙野, 殷凤龙, 杨丹, 等. 复杂激励下变速箱箱体动态响应分析[J]. 机床与液压, 2014, 42(19): 78-81+96 doi: 10.3969/j.issn.1001-3881.2014.19.021SUN Y, YIN F L, YANG D, et al. Dynamic analysis of gearbox housing under complex dynamic excitation[J]. Machine Tool & Hydraulics, 2014, 42(19): 78-81+96 (in Chinese) doi: 10.3969/j.issn.1001-3881.2014.19.021 [3] FURCH J, TRAN C V. Vibration analysis of multi-body dynamic model of combat vehicle gearbox[J]. MATEC Web of Conferences, 2019, 287: 03005 doi: 10.1051/matecconf/201928703005 [4] 杨广雪, 李广全, 刘志明, 等. 轮轨激励下高速列车齿轮箱箱体振动特性分析研究[J]. 铁道学报, 2017, 39(11): 46-52 doi: 10.3969/j.issn.1001-8360.2017.11.007YANG G X, LI G Q, LIU Z M, et al. Vibration characteristics analysis of gearbox housing system of high-speed train subjected to wheel-rail excitation[J]. Journal of the China Railway Society, 2017, 39(11): 46-52 (in Chinese) doi: 10.3969/j.issn.1001-8360.2017.11.007 [5] 温昌凯, 谢斌, 杨子涵, 等. 基于功率密度的大功率拖拉机变速箱壳体疲劳分析[J]. 农业机械学报, 2019, 50(6): 389-396+404 doi: 10.6041/j.issn.1000-1298.2019.06.046WEN C K, XIE B, YANG Z H, et al. Fatigue analysis of gearbox shell of high horsepower tractor based on power density[J]. Transactions of the Chinese Society for Agricultural Machinery, 2019, 50(6): 389-396+404 (in Chinese) doi: 10.6041/j.issn.1000-1298.2019.06.046 [6] SALVINI P, VIVIO F, VULLO V. Fatigue life evaluation for multi-spot welded structures[J]. International Journal of Fatigue, 2009, 31(1): 122-129 doi: 10.1016/j.ijfatigue.2008.06.006 [7] BARKE D W, CHIU W K. A review of the effects of out-of-round wheels on track and vehicle components[J]. Proceedings of the Institution of Mechanical Engineers, Part F:Journal of Rail and Rapid Transit, 2015, 219(3): 151-175 [8] 高娜, 冯慧华, 杨石秋, 等. 刚度耦合影响下的变速器箱体结构动态分析及疲劳寿命预估[J]. 机械强度, 2017, 39(1): 221-225GAO N, FENG H H, YANG S Q, et al. Dynamic analysis of the gear-box case structure based on stiffness coupling and its life estimation of vibration fatigue[J]. Journal of Mechanical Strength, 2017, 39(1): 221-225 (in Chinese) [9] 陈婷, 赵文峻, 马天飞. 路面激励下变速器箱体疲劳寿命预估方法研究[J]. 汽车技术, 2012(11): 30-34 doi: 10.3969/j.issn.1000-3703.2012.11.009CHEN T, ZHAO W J, MA T F. Research on prediction method for fatigue life of transmission gearbox housing under road excitation[J]. Automobile Technology, 2012(11): 30-34 (in Chinese) doi: 10.3969/j.issn.1000-3703.2012.11.009 [10] 邓国红, 李玉, 杨鄂川, 等. 重型汽车变速器箱体结构强度及疲劳分析[J]. 重庆理工大学学报(自然科学), 2016, 30(2): 12-16DENG G H, LI Y, YANG E C, et al. Body structure strength and fatigue analysis on the gear-box of heavy vehicle[J]. Journal of Chongqing University Technology (Natural Science), 2016, 30(2): 12-16 (in Chinese) [11] 时辉. 混合动力拖拉机动力系统设计研究[D]. 洛阳: 河南科技大学, 2014SHI H. The design and research of HET's power system[D]. Luoyang: Henan University of Science and Technology, 2014 (in Chinese) [12] 黄健, 王忠山, 马文星, 等. 拖拉机工作路面谱测量与分析[J]. 拖拉机与农用运输车, 2018, 45(4): 20-24HUANG J, WANG Z S, MA W X, et al. Measurement and analysis of road spectrum of tractor working pavement[J]. Tractor & Farm Transporter, 2018, 45(4): 20-24 (in Chinese) [13] 姚艳春, 杜岳峰, 朱忠祥, 等. 基于模态的玉米收获机车架振动特性分析与优化[J]. 农业工程学报, 2015, 31(19): 46-53 doi: 10.11975/j.issn.1002-6819.2015.19.007YAO Y C, DU Y F, ZHU Z X, et al. Vibration characteristics analysis and optimization of corn combine harvester frame using modal analysis method[J]. Transactions of the Chinese Society of Agricultural Engineering, 2015, 31(19): 46-53 (in Chinese) doi: 10.11975/j.issn.1002-6819.2015.19.007 [14] 王岩, 王晓晴, 郭生荣, 等. 航空柱塞泵缸体疲劳分析及寿命预测方法[J]. 北京航空航天大学学报, 2019, 45(7): 1314-1321WANG Y, WANG X Q, GUO S R, et al. Fatigue analysis and life prediction method for cylinder block of aviation piston pump[J]. Journal of Beijing University of Aeronautics and Astronautics, 2019, 45(7): 1314-1321 (in Chinese) [15] 丁金滨. Ansys Workbench 18.0有限元分析案例详解[M]. 北京: 清华大学出版社, 2019DING J B. Ansys Workbench 18.0 finite element analysis case detailed explanation[M]. Beijing: Tsinghua University Press, 2019 (in Chinese) [16] SHEN G, XIANG D, ZHU K, et al. Fatigue failure mechanism of planetary gear train for wind turbine gearbox[J]. Engineering Failure Analysis, 2018, 87: 96-110 doi: 10.1016/j.engfailanal.2018.01.007 [17] 黄宁. 大型结构件的疲劳寿命预测方法研究[D]. 长沙: 中南大学, 2012HUANG N. Research on fatigue life prediction methods for large-scale components[D]. Changsha: Central South University, 2012 (in Chinese) [18] 赵少汴. 抗疲劳设计手册[M]. 北京: 机械工业出版社, 2015ZHAO S B. Anti-Fatigue design[M]. Beijing: China Machine Press, 2015 (in Chinese) [19] 高天阳, 肖守讷, 杨冰, 等. 修正准静态叠加法下的齿轮箱箱体寿命预测[J]. 机械科学与技术, 2019, 38(3): 480-486GAO T Y, XIAO S N, YANG B, et al. Life prediction of gearbox body by modified quasi-static superposition method[J]. Mechanical Science and Technology for Aerospace Engineering, 2019, 38(3): 480-486 (in Chinese)