利用压力损失补偿方法提高气力提升装置性能研究

汪朝晖; 杨霄; 高全杰

doi:10.13433/j.cnki.1003-8728.2018.0205

利用压力损失补偿方法提高气力提升装置性能研究

doi: 10.13433/j.cnki.1003-8728.2018.0205

1.
武汉科技大学机械自动化学院, 武汉 430081

基金项目:

国家自然科学基金项目（51405352）资助

详细信息

作者简介:
汪朝晖(1981-),教授,博士,研究方向为机械装备设计理论与方法,zhwang@wust.edu.cn

计量
- 文章访问数: 171
- HTML全文浏览量: 37
- PDF下载量: 3
- 被引次数: 0
出版历程
- 收稿日期: 2016-12-07
- 刊出日期: 2018-02-25

Study on Improving the Performance of Air Lift Device by Pressure Loss Compensation Method

1.
Department of Mechanical Automation, Wuhan University of Science and Technology, Wuhan 430081, China

摘要

摘要: 基于多相流流型及垂直管道提升沿程压力损失机理，依据压力损失补偿方法，提出了管径"压力损失补偿系数"。结合模拟气力提升实验理论，建立了气力提升装置物理模型，设计了气力提升新型管道结构。计算了不同进气量和浸入率下压力损失补偿系数对气力提升排水量的影响，分析了不同压力损失补偿系数下的气力提升装置排水量及提升效率。研究结果表明：管径影响气力提升沿程压力损失，在一定范围内管径越大，管道沿程压力损失越小。合理的压力损失补偿系数能改变管道结构形状，减小管道摩擦阻力，进而降低气力提升过程中的管道压力损失并改变多相流流型相变点位置，提高气力提升装置效率。以排水量表征气力提升装置性能，不同进气量和浸入率下，压力损失补偿系数为正时，多相流流型受提升管道内压力损失影响降低，沿程气力提升装置排水量提高；压力损失补偿系数在0~4°逐渐增大，气力提升装置排水量先上升后趋于平稳；进气量为4.2 kg/h和2.5 kg/h时，排水量在压力损失补偿系数为2.5°~3°和0.7°~1°时达到较高值，其气力提升装置效率提高最大值分别为14.6%与9.5%。
- 气力提升 /
- 效率 /
- 压力补偿系数 /
- 管道结构设计
Abstract: Based on the multiphase flow pattern and pressure loss mechanism of vertical pipe lifting, the pressure loss compensation coefficient of pipe diameter is proposed according to the pressure loss compensation method. The physical model of the air lift device was established based on the theory of simulated air lift. The new type air lift pipeline structure was designed. The influence of pressure loss compensation coefficient on mass flow rate of air lift under different air flow rate and immersion rate was calculated. Based on this analysis, the water flow rate and lifting efficiency of the gas lift equipment under different compensation coefficients were analyzed. The results show that the diameter of the pipeline has influence on the pressure loss, and the larger the pipe diameter is, the smaller the pressure loss is. The reasonable pressure compensation coefficient can reduce the pressure loss of the pipeline by changing the shape of the pipeline structure, and reduce the pressure loss of the pipeline during the lifting process, thus changing the position of the phase change point of the multiphase flow pattern and improving the efficiency of air lift device. Mass flow rate is the very parameter to measure the ability of air lift device, when the pressure compensation coefficient is positive, the pressure loss of the multiphase flow pattern is reduced and the water flow rate of the air lift device is improved. When the pressure compensation coefficient is increasing from 0 to 4°, the water flow rate of air lift starts to improve and tends to stabilize. When the air flow rate is 4.2 kg/h and 2.5 kg/h, the water flow rate increases to a higher value when the pressure compensation coefficient is 2.5°~3° and 0.7°~1°, and the maximum efficiency of air lift increases by 14.6% and 9.5%.
- air lift /
- efficiency /
- pressure loss compensation coefficient /
- structural design

HTML全文

参考文献(16)

[1]	王鑫,郭烈锦.气举消除严重段塞流方法的实验研究[J].工程热物理学报,2007,28(4):607-610 Wang X, Guo L J. Experimental study of gas-lift method for severe slugging elimination[J]. Journal of Engineering Thermophysics, 2007,28(4):607-610(in Chinese)
[2]	李炜.大洋采矿的气力提升特性[J].中国有色金属学报,1993,3(1):81-86 Li W. Gas lift characteristics of characteristics of ocean mining[J]. China Nonferrous Metals, 1993,3(1):81-86(in Chinese)
[3]	胡志华,钱焕群,鹿院卫,等.水平管内油-气-水三相流流型的研究[J].西安交通大学学报,2001,35(9):899-902,913 Hu Z H, Qian H Q, Lu Y W, et al. Oil-gas-water three-phase flow pattern in horizontal tubes[J]. Journal of Xi'an Jiaotong University, 2001,35(9):899-902,913(in Chinese)
[4]	杜鹏,卢义玉,张磊,等.喷射气举提升性能实验分析[J].重庆大学学报,2015,38(3):1-7 Du P, Lu Y Y, Zhang L, et al. Experimental research on lifting capability of jet air-lift[J]. Journal of Chongqing University, 2015,38(3):1-7(in Chinese)
[5]	胡东,吴霞,唐川林,等.钻孔水力开采用气力提升装置的实验研究[J].机械科学与技术,2013,32(5):756-761 Hu D, Wu X, Tang C L, et al. Experimental study of airlift device for borehole hydraulic jet mining[J]. Mechanical Science and Technology for Aerospace Engineering, 2013,32(5):756-761(in Chinese)
[6]	Esen I I. Experimental investigation of a rectangular airlift pump[J]. Advances in Civil Engineering, 2010,2010:789547
[7]	Hernández-Jiménez F, Sánchez-Delgado S, Gómez-GarcíA, et al. Comparison between two-fluid model simulations and particle image analysis & velocimetry (PIV) results for a two-dimensional gas-solid fluidized bed[J]. Chemical Engineering Science, 2011,66(17):3753-3772
[8]	Patro P, Jena S, Patro B. Numerical modeling of dilute particulate flows in horizontal and vertical pipes[J]. International Journal of Current Engineering and Technology, 2012,2(3):300-304
[9]	Shang Z, Lou J, Li H Y. CFD analysis of bubble column reactor under gas-oil-water-solid four-phase flows using Lagrangian algebraic slip mixture model[J]. International Journal of Multiphase Flow, 2015,73:142-154
[10]	于莉娜,李英伟,郭学涛,等.垂直上升管内油气水三相流数值模拟方法研究[J].油气田地面工程,2010,29(3):15-16 Yu L N, Li Y W, Guo X T, et al. Study on numerical simulation of oil-gas-water three-phase flow in upward vertical tube[J]. Oil-Gasfield Surface Engineering, 2010,29(3):15-16(in Chinese)
[11]	Samaras V C, Margaris D P. Two-phase flow regime maps for air-lift pump vertical upward gas-liquid flow[J]. International Journal of Multiphase Flow, 2005,31(6):757-766
[12]	王绍周.管道运输工程[M].北京:机械工业出版社,2004 Wang S Z. Pipeline transportation engineering[M]. Beijing:China Mechine Press, 2004(in Chinese)
[13]	Khalil M F, Elshorbagy K A, Kassab S Z, et al. Effect of air injection method on the performance of an air lift pump[J]. International Journal of Heat and Fluid Flow, 1999,20(6):598-604
[14]	唐川林,蔡书鹏,胡东,等.气举技术在矿物开采中的实验研究[J].应用基础与工程科学学报,2009,17(3):374-379 Tang C L, Cai S P, Hu D, et al. Experimental study on an air-lift in mining[J]. Journal of Basic Science and Engineering, 2009,17(3):374-379(in Chinese)
[15]	陆大玮.脉冲气提装置的研究[D].北京:机械科学研究总院,2007:31-35 Lu D W. Research on pulse air lift device[D]. Beijing:China Academy of Machinery Science & Technology, 2007:31-35(in Chinese)
[16]	刘永辉.气举系统效率评价方法研究[D].成都:西南石油学院,2002:33-37 Liu Y H. Study on efficiency evaluation method of gas-lift system[D]. Chengdu:Southwest Petroleum University, 2002,33-37(in Chinese)