Articles:2012,Vol:17,Issue(1):24-27
Citation:
RUAN Xiao-guang, CAO Han-xin, LI Fu-yang, ZHANG Dang-fei. The Analysis of the Combined Territorial Machining and Contour Line Machining Based on the CAXA Manufacturing Engineer 2004[J]. International Journal of Plant Engineering and Management, 2012, 17(1): 24-27

The Analysis of the Combined Territorial Machining and Contour Line Machining Based on the CAXA Manufacturing Engineer 2004
RUAN Xiao-guang, CAO Han-xin, LI Fu-yang, ZHANG Dang-fei
College of Mechanical and Electronic Engineering,Xi'an University of Architecture and Technology,Xi'an 710055,P. R. China
Abstract:
This paper introduces the rough machining of territorial machining and contour line machining based on the CAXA manufacturing engineer 2004,and gives an analysis of the combined machining of territorial machining and contour line machining. Finally,it proves the superiority of the combined machining by the example of high speed machining of an aluminium alloy lamina part.
Key words:    CAXA    territorial machining    contour line machining   
Received: 2011-12-12     Revised:
DOI:
Funds: This paper is supported by the Natural Science Foundation of Xi'an University of Architecture and Technology under Grant No.JC0919
Corresponding author:     Email:
Author description:
Service
PDF(579KB) Free
Print
Authors

References:
[1] Chen M,Liu G,Zhong J W,CAXA mauufac-turiug eugiueer 2004}VC Machiuiug. Beijing:Beijing Aerospace University Press,2006(InChinese)
[2] Yan G Q,Sun H Y,Li D,The complex graph-is NC milling machine based on CAXA mauu-facturiug Engineer 2004. Mechanical Engi-Neer,10,2009 (In Chinese)
[3] Peng Z Q,Du W J,Gao X Y,CAXA mauufac-turiug eugiueers 2004 practical tutorial. Beijing:Chemical Industry Press,2005 (In Chinese)
[4] Song W K,CAXA mauufacturiug eugiueer xp.Beijing:Beijing Aerospace University Press2003 (In Chinese)
[5] Lu J S,Li X,Xie X X,3D modeling and NCprogramming. Beijing:Tsinghua UniversityPress,2004 (In Chinese)
[6] Ai X,High-peed machining techuolog.Beijing:National Defense Industry Press,2003 (In Chinese)
Similar articles:
1.RUAN Xiao-guang, CAO Han-xin, LI Fu-yang, ZHANG Dang-fei.The Analysis of the Combined Territorial Machining and Contour Line Machining Based on the CAXA Manufacturing Engineer 2004[J]. International Journal of Plant Engineering and Management,