|
|
论文:2022,Vol:40,Issue(3):602-609 |
|
|
引用本文： |
|
|
胡金鑫, 郑光华, 孟玉航, 魏邦, 余柯锋. 单点总压探针安装位置对压气机进口级出口流场及测量结果的影响[J]. 西北工业大学学报 |
|
|
HU Jinxin, ZHENG Guanghua, MENG Yuhang, WEI Bang, YU Kefeng. Influence of single-point total pressure probe installation position on the flow field and measurement results of the inlet stage outlet of the compressor[J]. Northwestern polytechnical university |
|
|
|
|
|
|
|
| 单点总压探针安装位置对压气机进口级出口流场及测量结果的影响 |
|
| 胡金鑫1, 郑光华1, 孟玉航1, 魏邦1, 余柯锋2 |
|
1. 西北工业大学 动力与能源学院, 陕西 西安 710129;
2. 中国航发湖南动力机械研究所 测试技术部, 湖南 株洲 412002 |
| 摘要: |
| 采用数值模拟的方法,研究了某涡轴发动机压气机进口级出口流道中单点L型总压探针的测量精度以及探针对流场的影响,分析在巡航、最大连续、起飞3个典型工作状态下,探针测量结果随流量的变化规律,以及安装位置对探针测量结果的影响。研究结果表明:随着进口流量增加,探针的测量误差逐渐增加,当D/d为6.5时,探针总压相对测量误差最小,且测量误差与流量呈线性关系;相较于叶背,当安装位置在叶盆附近时,探针总压相对测量误差最大;当探针安装位置越靠近叶背,探针下游的总压损失系数下降速度越慢,探针在流向的影响范围更大;当安装位置在叶盆和叶背附近时,探针下游5~24 mm之间的速度均匀度较小。 |
| 关键词:
压气机进口级出口
总压探针
测量误差
速度均匀度
总压损失系数
|
|
| Influence of single-point total pressure probe installation position on the flow field and measurement results of the inlet stage outlet of the compressor |
|
| HU Jinxin1, ZHENG Guanghua1, MENG Yuhang1, WEI Bang1, YU Kefeng2 |
|
1. School of Power and Energy, Northwestern Polytechnical University, Xi'an 710129, China;
2. AECC Hunan Aviation Power Plant Research Institute, Zhuzhou 412002, China |
| Abstract: |
| The measurement accuracy of a single-point L-type total pressure probe in the inlet stage outlet flow path of a vortex engine compressor and the influence of the probe on the flow field were investigated via numerical simulation. The change pattern of probe measurement results with flow rate under three typical operating conditions of cruise, maximum continuous and takeoff were analyzed, as well as the influence of the installation position on the probe measurement results. The present results show that the measurement error of the probe gradually increases with the increasing of inlet flow rate. The relative measurement error of total probe pressure is the smallest and the measurement error is linear with the flow rate at a ratio(D/d) of 6.5. The relative measurement error of the total probe pressure is greatest when the installation position is located near the leaf basin compared to the leaf back. As the probe is installed closer to the back of the leaf, the total pressure loss coefficient downstream of the probe decreases more slowly and the probe has a greater range of influence on the flow field in the flow direction. When the installation position is located near the leaf basin and leaf back, the velocity uniformity between 5 mm and 24 mm downstream of the probe is smaller. |
| Key words:
compressor inlet stage outlet
total pressure probe
measurement error
velocity uniformity
total pressure loss coefficient
|
|
| 收稿日期: 2021-08-26
修回日期:
|
| DOI: 10.1051/jnwpu/20224030602 |
| 通讯作者: 郑光华(1978—),西北工业大学副教授、博士,主要从事涡轮叶片新型冷却和涡轮气动热力学研究。e-mail:zhengguanghua@nwpu.edu.cn
Email：zhengguanghua@nwpu.edu.cn |
| 作者简介: 胡金鑫(1998—),西北工业大学硕士研究生,主要从事内流通道参数测量研究。
|
|
|
|
|
|
|
|
参考文献: |
|
|
[1] 赵安家. 大气总温测试系统误差对发动机调整与性能影响的研究[J]. 飞机设计,2015, 35(6): 33-38 ZHAO Anjia. Study on the effect of atmospheric total temperature test system error on engine tuning and performance[J]. Aircraft Design, 2015, 35(6): 33-38 (in Chinese)
[2] 马宏伟, 项乐. 探针支杆对压气机转子性能及流场影响的数值模拟研究[J]. 推进技术,2016,37(12): 2288-2295 MA Hongwei, XIANG Le. Numerical simulation study on the effect of probe struts on the rotor performance and flow field of compressor[J]. Propulsion Technology, 2016, 37(12): 2288-2295 (in Chinese)
[3] JAN Lepicovsky. Effects of a rotating aerodynamic probe on the flow field of a compressor rotor[R]. NASA/CR-2008-215215
[4] SIMON Coldrick, PAUL Ivey, ROGER Wells. Considerations for using 3-D pneumatic probes in high-speed axial compressors[J]. Transactions of the ASME, 2003, 125(1): 149-154
[5] 余柯锋. 中小型航空发动机叶型稳态压力探针设计及试验研究[J]. 电子测试, 2017(13): 16-17 YU Kefeng. Design and experimental study of steady-state pressure transducer for small and medium-sized aero-engine lobes[J]. Electronic Test, 2017(13): 16-17 (in Chinese)
[6] 魏崇, 向宏辉, 刘志刚, 等. 探针测量布局对中介机匣流场影响的试验研究[J]. 燃气涡轮试验与研究, 2020, 33(5): 44-47 WEI Chong, XIANG Honghui, LIU Zhigang, et al. Experimental study on the effect of probe measurement layout on the flow field of the intermediary magazine[J]. Gas Turbine Experiment and Research, 2020, 33(5): 44-47 (in Chinese)
[7] 高杰, 向宏辉, 代秋林, 等. 探针支杆尾迹特性对压气机叶栅性能的影响[J]. 燃气涡轮试验与研究,2019, 32(6): 6-13 GAO Jei, XIANG Honghui, DAI Qiulin, et al. Influence of probe stub trailing characteristics on the performance of compressor leaf grille[J]. Gas Turbine Experiment and Research, 2019, 32(6): 6-13 (in Chinese)
[8] 付少林, 杨荣菲, 刘长青, 等. 测试布局对涡轮效率的影响研究[J]. 推进技术, 2019, 40(11): 2464-2472 FU Shaolin, YANG Rongfei, LIU Changqing, et al. Study on the effect of test layout on turbine efficiency[J]. Propulsion Technology, 2019, 40(11): 2464-2472 (in Chinese)
[9] 朱高平, 薛伟鹏, 唐国庆, 等. 探针耙对跨声速环形涡轮叶栅流场的影响[J]. 燃气涡轮试验与研究,2019, 32(2): 28-33 ZHU Gaoping, XUE Weipeng, TANG Guoqing, et al. Influence of probe rake on the flow field of transonic annular turbine impeller grid[J]. Gas Turbine Experiment and Research, 2019, 32(2): 28-33 (in Chinese)
[10] 王肖, 惠呈程, 吕文召, 等. 亚声速条件下总压探针堵塞效应的数值研究[C]//中国航天第三专业信息网第四十届技术交流会暨第四届空天动力联合会议, 2019: 43-52 WANG Xiao, HUI Chengcheng, LYU Wenzhao, et al. Numerical study on the plugging effect of the total pressure probe under subsonic speed[C]//The 40th APTIS Technical Conference and 4th JCAP, 2019: 43-52 (in Chinese)
[11] 郑光华, 王肖, 郭林, 等. 亚声速条件下总压探针临壁效应的数值研究[J]. 航空工程进展, 2020, 11(2): 256-263 ZHENG Guanghua, WANG Xiao, GUO Lin, et al. Numerical study on the wall effect of total pressure probe under subsonic speed[J]. Advances in Aeronautical Engineering, 2020, 11(2): 256-263 (in Chinese) |
|
|
|
相关文献: |
|
|
1．郑光华, 水飞, 胡金鑫, 刘鑫, 肖华中.不同结构探针对压气机进口级流场及测量结果的影响[J]. 西北工业大学学报, 2021,39(4): 858-864 |
|
|
|
|
|
|
