论文:2019,Vol:37,Issue(6):1200-1208
引用本文:
李剑锋, 王三民, 彭麒安, 李飞. 正方形组合可展机构的位移模态和路径跟踪研究[J]. 西北工业大学学报
LI Jianfeng, WANG Sanmin, PENG Qi'an, LI Fei. Research on Displacement Mode and Path Tracking Method of Square Combined Deployable Mechanism[J]. Northwestern polytechnical university

正方形组合可展机构的位移模态和路径跟踪研究
李剑锋, 王三民, 彭麒安, 李飞
西北工业大学 机电学院, 陕西 西安 710072
摘要:
可展机构的运动路径不仅可以掌握机构是否按预期规律运动,而且为其运动控制提供理论支撑。为了精确研究正方形组合机构的运动学特性,首先基于螺旋理论和图论分析了正方形组合可展机构的可动性,然后在此基础上,推导了正方形组合可展机构的平衡矩阵,将其进行奇异值分解,得到了正方形组合可展机构的位移模态。其次通过位移模态的迭代,建立了正方形组合可展机构的路径跟踪方法。最后借助算例分析,确定了正方形组合可展机构的分岔点位置,分析了分岔点位置的变化规律以及它和平衡矩阵奇异值的正相关性,发现增加额外约束和规划合理路径可以避免出现分岔现象,为正方形组合可展机构的构型设计和参数优化提供了必要的参考数据。
关键词:    正方形组合可展结构    螺旋理论    可动性    平衡矩阵    位移模态    路径跟踪    运动学    奇异值分解    分岔   
Research on Displacement Mode and Path Tracking Method of Square Combined Deployable Mechanism
LI Jianfeng, WANG Sanmin, PENG Qi'an, LI Fei
School of Mechanical Engineering, Northwestern Polytechnical University, Xi'an 710072, China
Abstract:
The motion path of the developable mechanism can not only grasp whether the mechanism can move according to the expected law, but also provide theoretical support for motion control. In order to accurately study the kinematics of the square combined mechanism, the mobility of the square combined expandable mechanism is analyzed based on the screw theory and the graph theory. Then, the balance matrix of the square combined expandable mechanism is derived,and the displacement mode of the square combined expandable mechanism is obtained through singular value decomposition. Secondly, the path tracking method of the square combined expandable mechanism is established by the iteration of the displacement mode. Finally, by means of the example analysis, the position of the bifurcation point of the square combined expandable mechanism is determined; the variation law of the bifurcation point and its positive correlation with the singular value of the balance matrix is analyzed. It is found that adding additional constraints and planning a reasonable path can avoid bifurcation phenomenon. This research provides necessary reference data for configuration design and parameter optimization of the square combined expandable mechanism.
Key words:    square combined deployable mechanism    screw theory    mobility    balance matrix    displacement mode    path tracking    kinematics    singular value decomposition    bifurcation   
收稿日期: 2019-01-08     修回日期:
DOI: 10.1051/jnwpu/20193761200
基金项目: 国家自然科学基金(51175422)资助
通讯作者:     Email:
作者简介: 李剑锋(1974-),西北工业大学博士研究生,主要从事机构学与机器人学研究。
相关功能
PDF(1302KB) Free
打印本文
把本文推荐给朋友
作者相关文章
李剑锋  在本刊中的所有文章
王三民  在本刊中的所有文章
彭麒安  在本刊中的所有文章
李飞  在本刊中的所有文章

参考文献:
[1] CHU Zhengrong, DENG Zongquan, QI Xiaozhi, et al. Modeling and Analysis of a Large Deployable Antenna Structure[J]. Acta Astronautica, 2014, 95(1):51-60
[2] YOU Z, PELLEGRINO S. Cable-Stiffened Pantographic Deployable Structures. I-Triangular Mast[J]. AIAA Journal, 2012, 34(4):813-20
[3] CARPENTIERI G, SKELTON R E, FRATERNALI F. A Minimal Mass Deployable Structure for Solar Energy Harvesting on Water Canals[J]. Structural & Multidisciplinary Optimization, 2016, 55(2):1-10
[4] LEDERMAN G, YOU Z, GLIŠC B. A Novel Deployable Tied Arch Bridge[J]. Engineering Structures, 2014, 70:1-10
[5] Patel S N, Gupta S, Reynolds M S. The Design and Evaluation of an End-User-Deployable, Whole House, Contactless Power Consumption Sensor[C]//Proceedings of the Sigchi Conference on Human Factors in Computing Systems, 2010
[6] 沈金, 楼俊晖, 邓华. 杆系机构的可动性和运动分岔分析[J]. 浙江大学学报, 2009, 43(6):1083-1089 SHEN Jin, LOU Junhui, DENG Hua. Movability and Kinematic Bifurcation Analysis for Pin-Bar Mechanisms[J]. Journal of Zhejiang University, 2009, 43(6):1083-1089(in Chinese)
[7] 徐静. 铰接杆系机构的运动形态研究[D]. 杭州:浙江大学, 2007 XU Jing. Studies on the Kinematic Morphology of Pin-Bar Mechanisms[D]. Hangzhou:Zhejiang University, 2007(in Chinese)
[8] 谢雅琪, 关富玲. 基于折痕特性的柔性结构展开过程分析[J]. 工程设计学报, 2013, 20(6):482-488 XIE Yanqing, GUAN Fuling. Deployment Analysis of Flexible Structure Based on Characteristics of Creases[J]. Chinese Journal of Engineering Design, 2013, 20(6):482-488(in Chinese)
[9] DENG H, KWAN A. Unified Classification of Stability of Pin-Jointed Bar Assemblies[J]. International Journal of Solids & Structures, 2005, 42(15):4393-4413
[10] 张春, 王三民, 袁茹. 空间可展机构弹性动力学特性研究[J]. 机械科学与技术, 2007, 26(11):1479-1482 ZHANG Chun, WANG Sanmin, Yuan Ru. On Elastodynamic Characteristics of Space Deployable Mechanism[J]. Mechanical Science & Technology for Aerospace Engineering, 2007, 26(11):1479-1482(in Chinese)
[11] LI Bo, WANG Sanmin, YUAN Ru, et al. Dynamic Characteristics of Planar Linear Array Deployable Structure Based on Scissor-Like Element with Joint Clearance Using a New Mixed Contact Force Model[J]. Journal of Mechanical Engineering Science, 2016, 230(18):3161-3174
[12] 李剑锋, 王三民, 智常建等. 基于螺旋理论的正方形单元及其组合机构瞬时自由度分析[J]. 西北工业大学学报, 2017, 35(5):863-869 LI Jianfeng, WANG Sanmin, ZHI Changjian, et al. Instantaneous Mobility Analysis of Square Unit and Its Combined Mechanism Based on Screw Theory[J]. Journal of Northwestern Polytechnical University, 2017, 35(5):863-869(in Chinese)
[13] DAI Jiansheng. Screw Algebra and Lie Groups and Lie Anlgebras[M]. Beijing:Higher Education Press, 2014
[14] DIESTEL R. Graph Theory[M]. Berlin:Springer Publishing Company, Incorporated, 2018
[15] SANDOR M. Introduction to Matrix Theory[M]. Beijing:Beihang University Press, 2014