船用起重机升沉补偿系统分析

张大兵; 乌建中; 卢飞平; 来鑫

船用起重机升沉补偿系统分析

1.
同济大学机械工程学院, 上海 200092;
2.
湘潭大学机械工程学院, 湘潭 411105

详细信息

作者简介:
张大兵(1970-)，讲师，博士研究生，研究方向为机电液控制，zdbpost@163.com;乌建中(联系人)，教授，博士，wjz@tongji.edu.cn

张大兵(1970-)，讲师，博士研究生，研究方向为机电液控制，zdbpost@163.com;乌建中(联系人)，教授，博士，wjz@tongji.edu.cn

计量
- 文章访问数: 411
- HTML全文浏览量: 7
- PDF下载量: 3
- 被引次数: 0
出版历程
- 收稿日期: 2010-12-26
- 刊出日期: 2015-06-10

Analysis on Heave Compensation System of Ship-mounted Crane

1.
College of Mechanical Engineering, Tongji University, Shanghai 200092;
2.
College of Mechanical Engineering, Xiangtan University, Xiangtan 411105

摘要

摘要: 为了减少船用起重机在海上作业时风浪对吊装的影响,延长海上作业时间,介绍了一种船用起重机的升沉补偿系统。在LMS.AMESim软件平台上建立了系统的仿真模型,通过仿真对比分析了4种模式下系统的动态性能,同时运用Design Exploration优化工具箱对PID控制器参数进行了自动优化,结果表明:被动升沉补偿模式下钢丝绳张力变化最小,主动-被动升沉补偿模式下比例阀有死区补偿时能够消除94%的船体升沉运动对载荷的影响,而无死区补偿只能达到84%。最后将仿真得到的优化控制参数应用于试验装置的控制之中,减少了试验装置的调整时间,得到了比较好的试验结果。
- 船用起重机 /
- 主动-被动升沉补偿 /
- 复合油缸 /
- 比例阀死区补偿
Abstract: In order to reduce the impact of wave to the ship-mounted crane during offshore operation under rough weather conditions and extend its period of work time,a set of heave compensation system was developed for ship-mounted crane.The system simulation model was built by using LMS.AMESim software and its dynamic performances were obtained by simulating four kinds of models respectively,and the parameters of PID controller were automatically optimized by using the optimization toolbox of design exploration.The results indicated that the fluctuation of wire tension force was the least under passive heave compensation model;94% impact of ship heave motion to load was eliminated with dead band compensation for the proportional valve in active-passive heave compensation model;however only 84% without dead band compensation.By using optimal simulation parameters to controller of test equipment,less regulation time and more consistent results were derived.
- ship-mounted crane /
- active-passive heave compensation /
- combination cylinder /
- proportional valve dead band compensation

HTML全文

参考文献(7)

[1]	方晓旻.起重机和波浪补偿控制系统设计研究[D].哈尔滨:哈尔滨工程大学,2008
[2]	Dalmaijer J W,Kuijpers M R L.Heave Compensation Systemfor Deep Water Installation[R].Technical Report,Gusto Engi-neering,2003
[3]	刘贺,李彬,胡晓东.波浪补偿起艇绞车的研究[J].上海造船,2008,(2):30～31
[4]	路甬祥,胡大纮.电液比例控制技术[M].北京:机械工业出版社,1988
[5]	王渝,张文彬,刘勋.板坯连铸机动态轻压下液压伺服系统建模与仿真分析[J].机械科学与技术,2010,29(3):342～345
[6]	魏素芬,杨文林等.液压绞车主动升沉补偿控制研究[J].液压与气动,2009,(7):27～29
[7]	王涛,陶薇.基于AMESim的液压挖掘机运动仿真及控制参数优化[J].机床与液压,2009,(7):180～182